The blower came on and i noticed after several minutes it was just blowing cold air so i turned the t stat to off.
Rv electric heater blowing cold air.
Suburban rv furnace troubleshooting.
My atwood rv propane heater is igniting and the blower is blowing but the air is not very warm.
Several things can be checked for a cause in this case.
Note that rv most likely has little insulation while also being prone to causing the cold chilly air to leak inside.
In this case it would be great to invest in the best electric heater for rv.
After about 30 minutes the trailer had cooled off enough for the t stat to call for heat again.
Let us discuss the difference and how they work.
Anything under 10 5 will result in the fan operating but just blowing cold air as the gas valves will not open.
Due to that the vehicle will most likely be uncomfortable with the drop of temperature.
Next the control panel at the distribution center inside the rv to ensure there is power coming into the rv and the 12 volt automotive fuse is not blown.
Types of rv heaters.
Fan is running but furnace produces no heat.
After all a thermostat can be easily replaced with any rv model.
There are two major types of rv heaters and these are gas heaters and electric heaters.
Yesterday i turned on the furnace to take the chill out of the trailer and it quickly warmed right up and cycled off.
If you are using a portable heater it only releases warmth in the area where the heater is located.
Fan forced heaters circulate heat by pushing air through a heated electric element.
In terms of forest river furnaces they usually have issues with no ignition cold air blowing or will simply not start.
Most rv furnaces are controlled by a thermostat on the wall.
When compared to other manufacturers these problems don t seem as bad.
As a result the vent will work but no heat will be produced.
A read more.
A few people even reported problems with thermostats.
How an rv heater works actually depends on the type of heater that you are using.
An rv furnace has an internal sail switch that will prevent the machine from igniting in cases of air flow being insufficient for combustion.